Ultimaker 2+ and Ultimaker 3 Magnetic Base Install Guide
These are installation instructions for the GeckoTek Magnetic Base for the Ultimaker 2, 2+, Extended and Ultimaker 3. When you are finished, you will be able to use GeckoTek Build Plates without the need for clips or tape.
The install was demonstrated on a Z stage that was removed from the 3D printer. This was done for convenience and to allow for better pictures and is not necessary or recommended.
If you have questions or discover an issue with the installation process please let us know.
Total install time is 5-10 mins.
You will need the following to complete the installation process:
- M2x5 screws (included)
- Thin Phillips screwdriver
- Pliers or wrench
Step 1: Remove the stock glass build platform by rotating the retaining clips out of the way and sliding the glass plate forward.
Step 2: Loosen the 3 leveling screws that hold the print bed heater on. Remove the thumb nuts and screws and set them aside for later.
Step 3: Using a thin Phillips screwdriver, loosen the screws attaching the power and thermistor wires to the print bed heater. You should not be able to separate the print bed heater from the 3D Printer.
Step 4: The front two glass retaining clips will come off with the leveling screws. Using the allen wrench and pliers, remove the screws holding the back two clips on. Set the screws and nuts aside for later.
Step 5: Attach the Magnetic Base to the stock bed heater using the included M2.5 Screws. The mounting holes in the Magnetic Base line up with the small slots where the retaining clips that held the glass plate used to be.
Step 6: Attach the Magnetic Base with heater attached to the Z-carriage with the 3 leveling screws. Tighten finger tight with the thumb nuts and Phillips screwdriver.
Step 7: Attach the GeckoTek Build Plate to the Magnetic Base and center it. Then follow the manufacturer’s recommended bed leveling procedure with the Build Plate in place.
You are now ready to 3D Print with your GeckoTek Build Plate!
